Rock Hard 4X4 Full Width Front Bumper & Rear Bumper for 07-18 Jeep Wrangler JK

This bumper is made from ¼" CNC Laser cut and bent steel for consistent quality. Tapers down and back to protect the factory lower front cross frame and Sway-bar disconnect unit(if equipped). Provides the best possible approach angle without cutting of the factory frame. Winch is mounted low in bumper for those concerned about air flow. Gives full width protection with ¼" plate. Recessed factory fog light mountings are provided. Warn Power Plant works with this bumper and features a black powder coat finish.

The Rock Hard Jeep JK Wrangler Rear Bumper/Tire-Carrier is the only JK rear bumper on the market today that is made out of 1/4" thick plate steel. Designed with tapered ends for increased departure angles, this bumper will hold up to a 38" tire, comes standard with an integrated Class 2 hitch receiver, CB antenna mount, a horizontal Hi-Lift Jack mount with padlock provision and two 5/8" x 2-1/2" CNC D-Ring shackle mount with tabs that are welded on front, go through bumper and then are welded on the backside as well. All necessary hardware necessary for the installation is provided and an optional Jerry Can Mounts and a Rock Rack are all available for purchase separately. Shown with Tire Carrier.